Oklahoma SOK CDL General Knowledge Practice Test 7
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. Your truck has a backup alarm that sounds whenever reverse is selected. What may a driver rely on it for?
Show answer
Answer D: Very little; it warns some people but cannot show you what is behind the vehicle
An alarm may not be heard over yard noise or by someone wearing hearing protection, so it never replaces looking at the path yourself.
-
2. What are you checking when you pull the engine oil dipstick during the pre-trip?
Show answer
Answer A: That the oil level is within the safe operating range marked on the stick
The dipstick shows whether there is enough oil to lubricate and cool the engine, and a level outside the safe range must be corrected before driving.
-
3. Federal rules say a commercial vehicle may not be driven unless what is true of its cargo?
Show answer
Answer B: It is properly distributed and adequately secured
The basic federal requirement is that the load be distributed properly and secured well enough that it cannot move, whatever the paperwork says.
-
4. In hazard perception, what counts as a hazard?
Show answer
Answer C: Any road user or condition that could become a danger
A hazard is anything with the potential to create danger, which is why drivers are taught to spot them early rather than react to emergencies.
-
5. Does the federal texting ban apply to a company dispatching device mounted in the cab?
Show answer
Answer B: Yes, entering or reading text on it while driving is banned
The rule is written around the act of reading or entering text on any electronic device, not around who owns the device.
-
6. How should the steering wheel be held when driving a large vehicle?
Show answer
Answer D: Firmly with both hands, placed on opposite sides of the wheel
Both hands on opposite sides give the leverage and control needed if a tire drops off the pavement or the wheel is jolted.
-
7. On a wet road, a commercial driver should reduce speed by roughly how much?
Show answer
Answer C: By about one third
Cutting speed by roughly a third, for example from 55 to about 35 mph, restores a margin for the traction lost on a wet surface.
-
8. A driver is tailgating you, honking and making gestures. What is the best response?
Show answer
Answer A: Do not make eye contact, ignore the gestures and give the driver room to get past
Engaging an aggressive driver only escalates the situation; the safest move is to stay calm, avoid eye contact and let the driver get by.
-
9. Which of these is NOT on the federal list of parts and accessories the driver must be satisfied are in good working order before driving?
Show answer
Answer D: The seat cushion upholstery
The federal pre-trip rule names brakes, steering, lights and reflectors, tires, horn, wipers, mirrors, coupling devices, wheels and rims, and emergency equipment; seat upholstery is not on that list.
-
10. Two tires in a dual set have noticeably different diameters. Why is that a problem?
Show answer
Answer C: The larger tire carries more than its share of the load and can be overloaded
The taller tire touches the road first and takes most of the weight, so it runs overloaded and hot while the smaller one does little work.
-
11. A fire has started in the vehicle. How should the extinguisher be used?
Show answer
Answer B: Stay as far back as the reach of the extinguisher allows, stand upwind, and aim at the base of the fire
Aiming at the base attacks what is actually burning, and staying upwind and well back protects the driver from heat, smoke and the flames themselves.
-
12. What must the motor carrier do about a defect listed on a driver vehicle inspection report?
Show answer
Answer D: Repair it, or certify that repair is not needed, before the vehicle is dispatched again
A reported defect must be corrected, or certified as not needing correction, and that certification is what the next driver reads before taking the vehicle.
-
13. Your right wheels drop off the pavement onto a soft shoulder. What is the correct recovery?
Show answer
Answer A: Stay on the shoulder, ease off the accelerator, brake gently only once speed is down to about 20 mph, then steer back sharply and countersteer at once
Bringing speed down on the shoulder first avoids a violent sideways jolt, and countersteering the instant the tires are back on the pavement keeps the vehicle out of the next lane.
-
14. Which items belong to the trailer part of the walkaround inspection?
Show answer
Answer D: Landing gear, doors, tires, wheels, lights, reflectors, frame and cargo securement
The trailer has its own running gear, lighting, structure and load, and all of it is the responsibility of the driver pulling it.
-
15. Which vehicle is most likely to be pushed around by a strong crosswind?
Show answer
Answer B: An empty van trailer
A large flat side with very little weight behind it gives the wind the most surface and the least resistance, which is the empty van trailer.
-
16. What is the purpose of blocking placed against cargo on a trailer deck?
Show answer
Answer B: To fill the space around the cargo so it cannot slide
Blocking is shaped to fit snugly against the cargo and fastened to the deck, removing the room the load would need in order to move.
-
17. How does a driver measure following distance in seconds?
Show answer
Answer A: Wait for the vehicle ahead to pass a fixed roadside object, then count the seconds until the front of your vehicle reaches the same object
Counting from the moment the vehicle ahead passes a landmark until you reach it turns a gap you cannot judge in feet into a number of seconds.
-
18. What are you checking when you look at the batteries during the engine compartment inspection?
Show answer
Answer D: That they are securely mounted, the connections are tight and free of corrosion, and the caps are in place
Loose or corroded batteries can fail or short out, so the mount, cables, terminals and vent caps are all part of the check.
-
19. On a set of dual tires, which condition must be reported as a defect?
Show answer
Answer D: The two tires are touching each other or rubbing on part of the vehicle
Duals that touch each other or the vehicle overheat and wear quickly, so they must be separated by proper spacing and inflation before driving.
-
20. The shipper hands you the placards for a load that needs them. Who puts them on the vehicle?
Show answer
Answer C: The driver, who must also make sure they are the correct ones and are readable
The shipper supplies the placards, but it is the driver who must place them on the vehicle and confirm that they match the load and can be read.
-
21. On a two lane road carrying traffic in both directions, where do the three warning devices go?
Show answer
Answer C: About 10 feet from the vehicle on the traffic side, 100 feet behind and 100 feet ahead
Traffic can approach from either direction, so one device goes close to the vehicle and one is placed about 100 feet away in each direction.
-
22. You want to check whether a tire on your truck is properly inflated. What is the correct method?
Show answer
Answer A: Measure the pressure with a tire gauge
Only a tire gauge tells you the actual pressure; a tire can look and sound normal while being badly underinflated.
-
23. A car that passed you on the right slows and stays alongside your trailer. What is the best response?
Show answer
Answer D: Ease off the accelerator so the car can move clear
A vehicle sitting beside a trailer is in a blind area and has nowhere to go if you need the lane, so the safest fix is to let it get ahead or behind.
-
24. After coupling, where should the fifth wheel release handle be?
Show answer
Answer A: In the locked position with the safety latch in place
The handle must be pushed in and latched, because a handle left out means the jaws can open and release the trailer while you are driving.
-
25. Which of these is a major cause of skids in heavy vehicles?
Show answer
Answer C: Over-braking, over-steering, over-acceleration or driving too fast for conditions
Skids happen when the tires are asked for more grip than the road can give, which happens through braking, steering or accelerating too hard or simply too much speed.
-
26. You are driving past a park where children are playing close to the curb. What is the correct assumption?
Show answer
Answer A: A child may run into the street without looking
Children act on impulse and do not judge traffic well, so a driver has to expect one to enter the road and slow down in advance.
-
27. Most rollovers of loaded trucks on exit and entrance ramps happen for which reason?
Show answer
Answer B: The ramp was taken faster than the load could tolerate
A posted ramp speed is set for cars, and a loaded trailer with a high center of gravity can roll at a speed a car would take easily.
-
28. What is the purpose of the header board, or headache rack, that you inspect behind the cab?
Show answer
Answer A: It protects the driver from cargo that shifts forward during a hard stop
In a hard stop the load keeps moving forward, and the header board is the barrier between that load and the back of the cab.
-
29. What speed and gear should be used when backing a large vehicle?
Show answer
Answer B: As slowly as possible, in the lowest reverse gear
Backing slowly in the lowest reverse gear keeps the vehicle under precise control and leaves time to correct the path.
-
30. You are dropping a loaded trailer in a yard. How far should the landing gear be lowered?
Show answer
Answer A: Until the pads make firm contact and the trailer weight is just off the fifth wheel
Cranking down until the gear is firmly on the ground and just lifting the load off the fifth wheel makes the trailer stable and lets the tractor pull out cleanly.
-
31. How does a driver keep a vehicle with a manual transmission from rolling back when starting on an upgrade?
Show answer
Answer D: Partly engage the clutch before the right foot leaves the brake, or hold the vehicle with the parking brake until the engine pulls
Something has to hold the vehicle during the instant the foot moves from the brake to the accelerator, and that is either the clutch at its engagement point or the parking brake.
-
32. Why are the windshield wipers on the pre-trip list even before a trip in fine weather?
Show answer
Answer C: Because weather can change and a wiper failure leaves the driver without a clear view
Rain, spray or mud can arrive at any point in a long trip, and a wiper that fails then leaves the driver with no way to clear the windshield.
-
33. Why does the commercial driver manual tell you to look far down the road instead of only at the vehicle ahead?
Show answer
Answer D: So you can adjust smoothly instead of braking hard at the last moment
A heavy vehicle cannot react quickly, so early information lets you slow gradually rather than make a sudden stop or swerve.
-
34. What does the driver check in the final step of the seven-step inspection?
Show answer
Answer A: Hydraulic brake leaks where those brakes are fitted, then the parking brake and the service brakes
The last step is done with the engine started: test for hydraulic leaks on vehicles with hydraulic brakes, then prove that the parking brake holds and that the service brakes stop the vehicle.
-
35. Total stopping distance is made up of which parts?
Show answer
Answer A: Perception distance, reaction distance and braking distance
The vehicle travels while the hazard is recognized, while the driver moves to the pedal, and again while the brakes slow the vehicle.
-
36. What is the correct way to make a right turn in a long vehicle?
Show answer
Answer D: Keep the rear of the vehicle close to the curb and swing wide only as you complete the turn
Swinging left before a right turn invites another driver to move into the gap on your right, so any extra width is taken as the turn is finished.
-
37. Besides allowing the move at all, what does an oversize load permit usually set out?
Show answer
Answer C: The route to be followed, the hours of travel allowed and the warning equipment needed
Permits for oversize movements normally name the roads that may be used, restrict the times of travel, and list the flags, signs and escorts required.
-
38. Which set of maneuvers makes up the basic control skills part of the commercial driving test?
Show answer
Answer D: Straight line backing, offset backing, parallel parking and alley docking
The basic control skills test is carried out off the road and consists of low speed exercises such as straight line backing, offset backing, parallel parking and the alley dock.
-
39. Under federal rules, which commercial vehicles must stop at every railroad crossing before proceeding?
Show answer
Answer D: Passenger buses and placarded hazardous materials vehicles
Buses carrying passengers and vehicles required to display hazardous materials placards must stop at crossings, while other commercial vehicles slow and check.
-
40. What must be true of the person who performs the annual periodic inspection?
Show answer
Answer D: They must meet the federal qualification requirements for an inspector
The inspection has to be done by someone who meets the federal training and experience requirements for inspectors, whoever employs them.
-
41. Why does a heavy vehicle need a much larger gap than a car in order to cross or enter traffic?
Show answer
Answer C: Because it accelerates slowly and needs far more road and time to clear the intersection
Slow acceleration combined with the length of the vehicle means a gap that would feel comfortable in a car is nowhere near enough.
-
42. How often must every commercial motor vehicle receive a periodic inspection?
Show answer
Answer C: At least once every twelve months
Federal rules require each commercial motor vehicle to pass a periodic inspection at least once in every twelve month period.
-
43. Which factors determine a safe speed for a long, steep downgrade?
Show answer
Answer C: The steepness and length of the grade, the weight of the vehicle and cargo, and the road and weather conditions
Gravity, weight and traction all decide how fast a heavy vehicle can safely descend, which is why signs often post lower speeds for trucks on grades.
-
44. Federal rules forbid operating a commercial vehicle in which condition?
Show answer
Answer C: In a condition likely to cause a crash or a breakdown
A defect that makes a crash or a breakdown likely has to be corrected before the vehicle is driven, not reported at the end of the trip.
-
45. Under the federal hours of service rules, how long may a property-carrying driver drive after 10 consecutive hours off duty?
Show answer
Answer D: Up to 11 hours, and only within a 14 hour window that starts when the driver comes on duty
The federal limit is 11 hours of driving after 10 consecutive hours off duty, and all of that driving has to fall inside a 14 hour window.
-
46. Before raising the hood to inspect the engine compartment, what should you do?
Show answer
Answer B: Shut off the engine, set the parking brake and chock the wheels if needed
The engine compartment is inspected with the engine off and the vehicle secured so nothing can move or turn while your hands are inside.
-
47. When does Oklahoma require the N tank vehicle endorsement?
Show answer
Answer C: For tanks with an individual capacity of more than 119 gallons and an aggregate capacity of 1,000 gallons or more
The Oklahoma N endorsement covers commercial vehicles designed to transport liquids or gases in tanks with an individual rated capacity of more than 119 gallons and an aggregate rated capacity of 1,000 gallons or more.
-
48. Within total stopping distance, what exactly is perception distance?
Show answer
Answer D: The distance traveled from the moment your eyes see a hazard until your brain identifies it
Perception distance covers only the time between seeing a hazard and recognizing it as a hazard, before any physical reaction begins.
-
49. What does gross vehicle weight mean, as opposed to gross vehicle weight rating?
Show answer
Answer B: The actual weight of the single vehicle plus everything it is carrying
Gross vehicle weight is what the vehicle actually weighs at that moment; the rating is the maximum the manufacturer allows it to weigh.
-
50. A strap runs from an anchor point on one side of the trailer, over the load, and down to an anchor point on the opposite side. How much of its working load limit counts toward the total required?
Show answer
Answer C: All of it
A tiedown that is anchored on one side, passes over or around the cargo and is anchored on the other side counts its full working load limit toward the aggregate figure.